CrossOver and redlight POI

 

Ok I am sorry if this have been asked before, I download the redlight POI file and used the editor to convert it, I then used the Magellan tools to copy it to my crossover. I then went to Nav> POI> enhanced and selected the file. I then took a drive to a known redlight site in PA and it did not work. What am I doing wrong?

Thanks for the help.

Paul

First of all, I don't know

First of all, I don't know squat about Magellans. However, are you sure that it is there, the POI I mean?

Do this (if it is possible with your unit)...

Go to the red light cam and then write down or save the coordinates. Then when you get home see if any of the coordinates match up.

--
Charley - Nuvi 350 - Bel STI Driver - Cobra 29 w/ wilson 1000 - AIM: asianfire -

What am I doing wrong?

pmorton wrote:

Ok I am sorry if this have been asked before, I download the redlight POI file and used the editor to convert it, I then used the Magellan tools to copy it to my crossover. I then went to Nav> POI> enhanced and selected the file. I then took a drive to a known redlight site in PA and it did not work. What am I doing wrong?

Thanks for the help.

Paul

Did you "Set Alarms" and "Alert Parameters" for that selected category ?

--
Nuvi 2595LMT

I think I did, can someone

I think I did, can someone tell me a step by step description from downloading the file converting it, installing and configuring it to work on a crossover?
Thanks’
Paul
Email pmort2000@11verizon.net
Remove the 11 to email

downloading the file converting

Check out this link, it might help.
http://www.poi-factory.com/node/7610

--
Nuvi 2595LMT