JCV not working with base camp route
Thu, 07/09/2015 - 2:16pm
 11 years
|
I decided to try and create a route with basecamp and then load it to my Garmin. Everything went fine doing that. I decided to run a simulation of the route. Everything was fine except I noticed that JCV wasn't working with the basecamp route. Anyone else experience this? I think I had this problem last year when doing the same thing, so I just had to create a route within my Garmin. I was just curious if this is normal with basecamp or if there's an issue with it. Thanks.
??
What do you mean when you say you run a simulation?
To me a simulation is run with the GPS function turned off and the device following whatever Go/route I asked for. The unit knows the speed I drive on various roads and so proceeds as if I were in fact in the car and driving. If my destination was 100 miles away, a "simulation" might take about 2 hours. A FAQ is at http://www.poi-factory.com/node/31482
I went into the settings and
I went into the settings and turned on the GPS simulator which turned the GPS off. Just wanted to see how the GPS would handle the basecamp route. I went through the list that shows all of the turns. Where you'd normally see a junction view of a turn, it wasn't showing one. Just the map of the turn. Ran the simulator up until the first junction view turn just to make sure and it didn't come up. It didn't pop up on the screen. It comes up in those same spots when I use my unit to do the routing. Not coming up for the basecamp route.
That is odd
I went into the settings and turned on the GPS simulator which turned the GPS off. Just wanted to see how the GPS would handle the basecamp route. I went through the list that shows all of the turns. Where you'd normally see a junction view of a turn, it wasn't showing one. Just the map of the turn. Ran the simulator up until the first junction view turn just to make sure and it didn't come up. It didn't pop up on the screen. It comes up in those same spots when I use my unit to do the routing. Not coming up for the basecamp route.
I hope someone can figure this out.
I do this all the time.
I went into the settings and turned on the GPS simulator which turned the GPS off. Just wanted to see how the GPS would handle the basecamp route. I went through the list that shows all of the turns. Where you'd normally see a junction view of a turn, it wasn't showing one. Just the map of the turn. Ran the simulator up until the first junction view turn just to make sure and it didn't come up. It didn't pop up on the screen. It comes up in those same spots when I use my unit to do the routing. Not coming up for the basecamp route.
I hope someone can figure this out.
I do what he said to check what a junction view looks like at each turn after creating a route. But, not with a route created on Base Camp.