How do I get out of a loop? (nuvi 660 / maintenance mode)
Sun, 10/14/2007 - 2:53am
|
18 years
|
I have a nuvi 660 and have never had any problems with it, until now. When I power up the unit it says “Do you really want to start up in maintenance mode?” The screen does not respond so it does not matter if I press no or yes. I have got it to respond a few times to no and it just reboots and comes back to the same screen. It seems like the screen does not respond to any input and I can’t get it out of this loop. I have tried holding down the power button but that just boots it back to the same screen. Anyone know what is going on? More importantly how do I fix it? Thanks in advance for any help you may give me.
See also
try a reset
you should have a reset button. try it to see if it will reboot.
etrex vista, Nuvi 350, Nuvi 650, Nuvi 750(3)
Tried, but did not work
I have used the reset on the back of the unit but all it does is reboot back to the same screen. any other ideas??
Call Garmin
I have used the reset on the back of the unit but all it does is reboot back to the same screen. any other ideas??
If you tried everything that you say you did, I would call Garmin Tomorrow to see what they have to say. Also if you are still under the Warranty
Richie
I will have to send it back
I did as you suggested and sent an email to Garmin. This is the reply;
Thank you for contacting Garmin International, We can go ahead and setup an RMA in warranty repair on the unit basically there is not much I can help you do in the way of troubleshooting this type of a problem, sounds like you have done the majority of your own troubleshooting, just reply back to me and I will get the ball rolling on an RMA for repair to your unit . With Best Regards,