Can I set my 260W to show an entire road?
Wed, 01/11/2012 - 8:21pm
14 years
|
Is there a way to set my 260W to show the entire length of a highway, e.g., Route 192 in Santa Barbara County, CA, USA, in the same manner as the gps will outline the route from one specific spot to another? I understand I could accomplish the task if I knew a specific address at each end of the road, but I don't....
Thanks in advance for your thoughts!
In a word, no
Not without a destination. Try using cities, or towns along the way though.
nüvi 3790T | Those who make peaceful revolution impossible, will make violent revolution inevitable ~ JFK
If you are at the start of
If you are at the start of the highway then you could tell the Nuvi to plot a route to the end of the highway by using the Where To-> Browse Map command. If you are not at the start of the highway turn on the GPS simulator (Tools-> Settings-> System-> GPS Simulator), then use Browse Map to set your location to the start of the route then use Browse Map again to plot a route to the end of the highway.
It might not work though, because the Nuvi will not necessarily stay on that particular highway if it thinks there is a better route. You could try using via points (if your unit has that feature) to keep the plotted route on the desired highway.